So my little machine shop 3503 kx3 has the 4th axis driver installed and the plug. Looking to utilize this just to learn some simple 4 axis programming. Little machine shop sells a setup with tail stock for $915 bucks which I think is excessive compared to what I've seen on eBay.
eBay 4th axis:
bit.ly
Little machine shop:
https://littlemachineshop.com/produc...3519&category=
I plan on eventually getting a tormach machine so maybe even this 6" rotary would work, something I can later use on the tormach. Not sure if it will properly fit but I'll measure.
30267 - 6" Motorized Table
Anyone have any advice, suggestions, stories, etc? The tormachs quality is attractive for the price and that I can use it later on, just have to see if it fits.