Hello, I recently purchased a 1996 EZ-PATH I from a trade school in Mass. The input voltage is wired for 460v. I want to change the input voltage to 240v 3 phase. There is a transformer in the top of the control panel that has input voltages listed on the front plate and specific wire and jumper locations. There is also a smaller transformer for the computer power supply which has volteges and locations specified. I don't want to burn up this machine and need some advice before proceeding. I don't know, Do I just put the wires in the specified locations and attach the 240 power or does the spindle motor also have to be rewired or replaced. I'm currently installing a 125amp sub panel and digital 20hp 3 phase converter. If anyone has experience with this situation please lend a helping hand. I would really appreciate it.
Thank You: Stan Sawyer