Update: I can start the spindle directly from the drive. It appears that the control is not sending the run signal to the drive. My troubleshooting tree says to check for open circuit between s1 and sc or between s2 and sc to determine is it is not getting a run signal or if it get both run and stop signals but I do not know how to check for an open circuit while the power is on so I unhooked the s2 stop signal wire and had the same result. This seems to indicate no run signal.
Hello,
I have a Hardinge Cobra 42 lathe with fanuc 21i-t control. It was sold to us with a turret problem that I have since fixed but the spindle does not work. The machine had all of its parameters wiped and input by hand but I have triple checked everything and nothing seems wrong with them now although I cant check the K Words. I also have an older working Cobra 42 (21i) that I can check against to get an idea of how everything is supposed to work.
Now for the problem:
When I turn on the spindle in MDI mode with any of the commands (m3/m13/m4/m14)(g97/g96) I hit cycle start and the cycle start button illuminates but the spindle does not start. The spindle rotates freely by hand (activated or not) and the spindle speed readout works when rotated by hand. There are no error codes at all and I have left it with the cycle start on for hours at a time with not change. The MagneTek 506 drive reads an input frequency but no output frequency, power, etc. There are three power output wires from the MagneTek to the motor and each of these read about 10V. In the PMC ladder I checked all of the "spindle starts here" logic against my working machine and it all seems to be in order. There are two rungs I have found that do not work properly and these are "M3 or M13" and "M3 Delay" these two rungs are supposed to be energized for a moment and then the spindle starts but on this machine they stay energized and the spindle does not start so this seems to be where the hang up is.
Other information that may or may not be related:
Coolant pump was not wired up until yesterday and without a diagram from when it was unhooked it may not be wired properly but I cant check it without activating the spindle.
Spindle bearings were replaced but the previous owner said the spindle worked before and after this operation.
Drive batteries died (thus the parameter wipe) and were very low when we got it but new batteries now.
Every other function works properly.
There is a toggle switch that is wired to the IO board to supply 12 volts but the output end is not attached to anything and the switch is in off position.
The spindle motor makes no noise to indicate it is running.
The spindle is attached to the motor via belt which seems to be at proper tension and rotates when the spindle is rotated by hand.
Any insight would be greatly appreciated,
Thank You