[seans52]

Hi All

Went down the Polyboard / V-Carve route, no problem with Polyboard creating units (kitchen, bedroom, studies, etc...) But having trouble getting the Biesse Rover B 4.40ft to read the nesting part (using V-Carve for nesting). Was told we need a post processor, then someone else told us we could get round it by another way (still trying to find that way)

Any help would be very welcome. Sean

[squarepusher]

Hey,
When you are saving your toolpath in Vcarve you should have a box with Post Processor in bold above a little pull down box, click on the arrow and it will give you a list of post processors to pick from. I see Biesse in available on my version of Vcarve.
If using that post does not work you can find the folder where the post is stored by clicking File and open application data folder in V-carve, go into PostP folder, find the Biesse post. Open it in a text editor and you can change what you need there.
Save the post under a different name before you go editing it.

Hope that helps,
J