I have a problem with my bridgeport ez trak dx 2 axis from 1995, when i start up the machine i do not get the messege to home the machine, and when i try to move the table with abs move i get a alarm "power on failed". i tried a couple of things but it's still not working.
does someone know what is the problem and what to do about it?
Thanks John Hoek
Results 1 to 3 of 3
-
10-11-2013, 03:12 PM #1
Registered
- Join Date
- Nov 2008
- Posts
- 9
Bridgeport Ez Trak "power on failed"
-
10-11-2013, 07:14 PM #2
Member
- Join Date
- May 2013
- Posts
- 128
it seems that servo are not initialized, or power up. Please check the servo power
-
10-11-2013, 11:41 PM #3
Registered
- Join Date
- Nov 2008
- Posts
- 9
the lights on the drives are both on, red and green. can it be a bad CR1 relay? or is it the bmdc board were i need to look at.
Reply With QuoteSimilar Threads
-
Hawk150-Acramatic2100 "NC Engine Failed"
By espinja in forum Cincinnati CNCReplies: 13Last Post: 12-16-2022, 10:05 PM -
X Axis "Goes Off Pattern", "Awry", "Skewed", "Travels"
By DaDaDaddio in forum Laser Engraving / Cutting Machine General TopicsReplies: 1Last Post: 05-06-2013, 09:59 AM -
Bridgeport Ez Trak SX - "No Cable" Error Message
By sullivnc in forum Bridgeport / Hardinge MillsReplies: 3Last Post: 04-10-2013, 12:03 AM -
Bridgeport EZ-Trak Replacement Monitor "New Color LCD"
By RADAPG1 in forum News AnnouncementsReplies: 2Last Post: 05-22-2011, 04:32 PM -
"Security Device Invalid or Has Failed"
By xray34 in forum HURCOReplies: 1Last Post: 08-03-2010, 09:16 PM
Posting Permissions
