Looking to have the following part created on a lathe. The measurements are in the photo. I am sure there will be questions as I am not sure all the information needed to give a quote is in here.
Thanks
Looking to have the following part created on a lathe. The measurements are in the photo. I am sure there will be questions as I am not sure all the information needed to give a quote is in here.
Thanks
Is that a metric tick or English?
Hello Mr Baseball
This is Vicky from China, wish that you would allow us to help you .
After I study the sketch you attached, I have questions as below before I send our offer to you :
1) what the material it is ?
2) what the surface finished it is ? is it anodosed ? painted? or else?
3)What the thickness it is ?
4) on the sketch, there are 2 cycles you filled in black, is it holes ? or others?