Hi guys, I hope someone can offer me some advice.
Does anyone know how to adjust these 3 screws to get the lathe to have more power at low speed so it doesn't keep stalling? I have tried turning them C.W. and C.C.W. 1-2 turns and it doesn't seem to have any effect. My first lathe was faulty and would take a tremendous load without stalling, so much so that it burned out the motor, so I believe it is possible to get at least some extra torque at low speed by adjusting these three screws, I just don't know which one(s), which way and how much.
Also, the lathe takes a short period of time to get up to speed in high gear, it didn't do that before. I have had the lathe for about 4 years.
Thank you for taking the time to read this.
Colin