Anyone have this issue before? It gives the error at the same spot on the table while cutting.
motor fault (0X 13)
Drive 1 (XA)
Drive 2 (Y)
Drive 5 (XB)
Thanks in advance for any information that might point me in the right direction.
Mike
Anyone have this issue before? It gives the error at the same spot on the table while cutting.
motor fault (0X 13)
Drive 1 (XA)
Drive 2 (Y)
Drive 5 (XB)
Thanks in advance for any information that might point me in the right direction.
Mike
Normally when you have a issue that is happening in the same are on the table, you are probably looking at a cable break. What is the blink count on the servo amps. Can you provide a picture of the servo amp.
I have a blink count 5 on all three drives. XA, Y, & XB
Thanks
Mike