My machine 1500GT is just ariived from China in 5 days.
Everythin is perfect working.
but a question, what must I change in the script of the zero's tool.
If I place the tool at the material and the mill makes contact it, it go's 20mm to high.
My machine 1500GT is just ariived from China in 5 days.
Everythin is perfect working.
but a question, what must I change in the script of the zero's tool.
If I place the tool at the material and the mill makes contact it, it go's 20mm to high.
Hello ,there
Do you use DSP 0501 handle ?
After you select a file , the screens will show you the parameters like Proc speed,Travl speed .... at the bottom is the Z up to .
Z up to means after place the tool at the material , the height the spindle is go up to .
Normally we set it to 10/20 mm .
Cheers,
Mary
Skype :Mary_xyz-tech