[LOGBOSS]

I am new to the CNC Forum.
I picked up a Bullard 3000 CNC lathe with bar feed on Ebay last fall. I'm just now getting it working. My last experience with CNC was allmost 20 years ago when I ran a CNC Power Hawk mill. I didn't think it was going to be this difficult to get this thing running. There are no manuals! I looked up basic g codes on the Internet and have done some basic programming, turret change, spindle, x-z axis motion. Good for manual chucking operations, but I need it to work in full auto.
The problem I am having is finding the codes for chucking , unchucking, and barfeed. If I can get this, I may be able to get some parts out of this thing.

[NC Cams]

Hint: do a google search for "Bullard 3000 CNC lathe"

Did it and found a gaggle of them here:

http://www.harrismachinetools.com/ne...mit2=Search%2B

With that many to sell, they might, just MIGHT, have a manual to copy or know where one can be procured.

Look DEEP into the google thing. You'd be amazed at what you can come up with....