[radicalrescue]

i have a 4x8 router table cnc 1224-1 its is losing count when it runs or i jog on x and y it 24h290-25 4b 3n.m running mach 3 ,i replaced the motors it still doing but not as bad..the motors seam to stall out when i jog ..any ideals

[ger21]

Reduce the acceleration and velocity

[radicalrescue]

my x 1017.860 vel78.54 acc 9.8 an my is y 2001.058 vel24.732 acc 2.99.....OK i just raised my y to 2028 an 50.004 an 10.847 it seams to work

[radicalrescue]

thanks ... now i have another problem ...i was setting the steps ,an just be low my reset button i had a ....simplify setting ...an i hit it by mistake now i have nothing but a white screen ..when i go to setting there is nothing there all my sets are gone

[radicalrescue]

thanks ger21 ,,just had them set way to low..i got my other problem fixed also...new tb6560 board .....does any one have a ideal why one step-er gets hot an the one on the same setting does not,,i am running a tb6560 ,a ms2h057m driver an steper 23hs3002 any help thanks alots ron