[Bryant303]

I obtained a used copy of Mastercam X recently. It seemed like a really good deal at the time, but now I am finding out that Mastercam will not help me out at all. I need to obtain a post processor for my Anilam 3300MK. I have no clue how I can go about this. I just figured on having to pay Mastercam a small amount for this post, but this is definently not the case. Any help would be greatly appreciated. Thanks!

[Bryant303]

If it helps, I am also using a HASP 4 dongle.

[Mike Mattera]

I Might have one send me an email.

Mike

[oldjohn]

G'day
If you have a post that works well from an older version of M'c you can use the post translation function or the Chooks to update postprocessors. It works pretty well. You may have to make minor adjustments afterwords to get it 100%.
Good luck
John

[sam1111]

Hi John:

I seen your post on the forum at CNCZone about the about upgrading a MC9 Anilam S1100 post to work with MC10. I was wondering if you could forward me a copy of this.
I have an Anilam S1100 control, it's a beautiful control however getting a post is difficult.

Thank you

Sam

[ricardop1968]

I'm new to this community, looking for a post for anilam 3300 that works for MCX. If you have one, please send me additional info to get it.

Thanks and Regards,
Ricardo

[Mike Mattera]

We have them here...
http://www.tipsformanufacturing.com/...rocessors.html

I know it says for V9, but we have both. Be sure to tell us which you want then placing your order.

Mike Mattera

[dserratt]

I need post processor for 3300m control
Thanks for any help