[betology]

Hello,

When I try to change tool (M6 T2)or spin the spindle (M3 S500) I get "ALARM 39-97 Spindle Drive not ready".
I new to this control, Do I have to enable something in the control?

VFS5 Spindle drive leds are:
ACTIVE: OFF
SYS OK: on
CPU: on
FAULT: on

Any advice will be helpful.
Thank you.
Attachment 212964

[mike_Kilroy]

fault on means drive is unhappy. can u rs232 in and ask it why it is sick? it will tell you. otherwise gotta take it out and send for rpr

Know it MIGHT be something external to the vfs5 too: it could be a bad spindle motor thermostat, bad spindle motor resolver position feedback, or bad spindle motor winding. these do not happen as often as drive failure though. another reason to use motionlink plus and ask drive what is wrong (it keeps the last 10 faults listed inside).

[betology]

I rs232 driver, it told me: ERR 12 'EN' OVER-CURRENT. Now I am checking wiring.

Thank You.

[mike_Kilroy]

good job.

so now you must find if short is INSIDE our OUTSIDE the vfs5 drive.

to do so, just unhook Ma,Mb,&Mc wires (spindle motor stator wires) off the screw terminal strip. Power back up: if same fault then the short is inside the vfs5; if it turns on without fault the short is outside the vfs5 (motor or cable).

[betology]

Thank you Mike, I unhooked Ma,Mb,&Mc wires, driver still says "ERR 12 'EN' OVER-CURRENT" when I tried to enable it "en".

[mike_Kilroy]

this GUARANTEES you have a blown output on your vfs5 drive. It is bad. Often when output IGBT blows it takes out 1/2 dozen components in the output stage DRIVER circuit also. This means if you just replace the output IGBT transistor it is likely the drive will simply blow the new one also.

You probably need to send this vfs5 to someone who repairs them daily. Sorry to say.

[Dutch_John]

Hello Mike,
At current we have a simular problem.
Cincinnati Milacron Arrow 750, using Acramatic 2100.
Alarm message 39-97.
VFS5 shwos:
Active: 0ff
SYS OK: on
CPU : on
Fault on

When I disconnect Ma, Mb & Mc the status of VFS5 changes to:
Active: on
SYS ok: on
CPU: on
Fault: off
So, if I understood correctly the issue should not be VFS5but the spindle drive itselve (or a wiring issue between drive and spindle).
Question: I have basis knowledge of electronics and computers, is it save to load Motion Link in my laptop and plug in to the VFS5?
We are afraid to damage software and/or settings.
In the past we had an experienced maintenance service here in The Netherlands, but at current we have to solve our own issues.
Can you advise?

[Muzamil2018]

Hi every one
I need cincinnati milacron Saber 1000 machine parameters
Please help me. 00966507104945
[email protected]