[jedgarG]

I had to replace the pmc-m board on the Fanuc controller for a Murata Centrum 2000 board. Of course the replacement board had the wrong ladder on the 0f1 and 0f2 eproms. Fanuc says they don't carry these and I would have to go through Murata but I thought I might check here first to see if anyone had this particular ladder. I have a copy of Fapt Ladder 1 so I can burn it even if it was just the files themselves.

[ifixcnc]

What happened to the original Eproms, you should be able to swap them onto the replacement board.

[jedgarG]

Sorry I should have mentioned I tried that but they don't work. The controller just stays on the boot screen. I can wipe the memory and it will boot up but as soon as I put the parameters back in and restart it does the same thing.

[noziz]

Hi JedgarG

Sorry for this inconvenience. I am in a trouble and i need your help.
I have too a Centrum 2000Q but my machine can't to work as normal because it is lost the parameter of the TDC controller block.
You can give me that parameter?
It is very necessarry with me.
Thanks & regard.

[dh08td]

Send eeprom data to my mail: [email protected]. i converter for you