[vacpress]

i only see 3-axis.... if that is a plasma torch, i only really see 2 axis.. 5?

[babinda01]

Hi VacPress,

There are five axis and also a plasma torch height control.

There are X, Y & Z axis, the plasma torch with its torch height control get mounted to the tee slots of the Z axis by a magnetic clamp system. The Plasma torch can be replaced by a Oxy torch also by means of the magnetic clamps. A router can be mounted to the Z axis by bolting to the tee slots.
There is a W axis which can have an engraver, centre drilling head or powder marking system fitted.
A rotary axis A is mounted down the side of the machine(a bit hard to see in the photos.

Andrew