Hi, I am currently putting together a post processor for a Mill master controller software operating a micro kinetics controller.
My feed rates should all be multiplied by 10 and not have any decimals or trailing zeroes after a decimal.
For example 59.6 IPM should look like
F596
and 9.5 IPM should output
F95
and 9 IPM should output
F90
In meshcam my correct line looks like this:
FORMAT = [F|#| F|1.0|10]
I have no idea how to do the equivalent in CamBam
Currently 9.5 IPM outputs F9.5 How do I multiply these values by 10 and suppress the decimal and that single trailing zero?