How to Connect Relays to the KFlop Controller???
Greetings,
Reading the info. on the website... it seems that the limit, for direct output, from the KFlop controller, is 3.3v @ 10ma. No add on cards.
If so, could someone give me a little guidance or diagram, as to how I can control a bank of 24vdc relays.
I do not want to buy the 32 I/O board, as my project must keep the cost way down.
The relays I use are 24vdc 200mW coil, would that be 8.4ma??
Does anyone make a board, that I could use to translate this to relay control. I can make my own board if needed.
I am looking for 8 outputs, Kflop to relay control.
__________________________________________________
Also, for inputs, do I run neg. to my switches and back to the inputs,... or Positive out and back?
Which is preferred?
Sincerely,
Jeff
Robot & Machine Design - BLUECNC4, GreenCNC3, RedCNC2L, SilverCNC2; CNC Software!
www.truemachinedesign.com - - - - - - - - - - - - - www.truemachineautomation.com