[sudirmi]

Please to help alarm 33 emergency stop when i started to run that machine in the morning.

I have Checked at main board control unit.
DC IN LED IS GREEN
DC OUT LED IS GREEN
PS EMG LED IS OFF.
BAT ALM LED IS OFF

I don't have electrical manual and ladder manual

Appreciate you.


Yude

[mazak-user]

Hi,
look at all servos, what you can see in the display.

Best regards
WWW.servotek-service.com

Gesendet von meinem PAP5000DUO mit Tapatalk

[sudirmi]

Hi,
Alarm led 7 on servo drive and spindle drive.
thank you and best regards,
Attachment 219294

[mazak-user]

OK. E7 is for emergency stop. Look also at MR-J2 for turret oder ATC or table.
type of the machine?
Best regards
Servotek

Gesendet von meinem PAP5000DUO mit Tapatalk

[sudirmi]

Hello,
Mazak Model : QT-200
Alarm led at MR-J2 are : AL-02-91-N1-01.
best regards,

[mazak-user]

This is also emergency stop. May be you get the emergency stop from outside. Have the machine a bar feeder.
Send a picture from page alarm history ( 3 pages )
Best regards
Servotek

Gesendet von meinem PAP5000DUO mit Tapatalk

[sudirmi]

Dear Mr.Mazak,
M/C don't have bar feeder.Please see attachment for alarm history.
Thanks & best regards,
Attachment 219444Attachment 219446

[mazak-user]

Hi,
you find out what happens?

Gesendet von meinem PAP5000DUO mit Tapatalk

[underthetire]

Says right there. Breaker trip 201. PLC is not up and running. Check circuit breakers first, then start checking power supplies.

[sudirmi]

Thank you for your reply.
i checked in the ladder diagram y1output is not actif caused of signal from X241 is not energize.i don't find x241 where come from.
Best regards.

[sudirmi]

i checked there are no breaker trip so power supply is ok.
best regard,