586,052 active members*
4,323 visitors online*
Register for free
Login
IndustryArena Forum > Laser Engraving and Cutting Machines > Commercial Laser > LOGILASE Laser > trace,draw,and copy diagrams output to dxf file laser ready

Thread: trace,draw,and copy diagrams output to dxf file laser ready

Results 1 to 2 of 2
  1. 01-20-2014, 02:54 AM #1
    woodman08
    woodman08 is offline Member
    Join Date
    Oct 2007
    Posts
    1022

    trace,draw,and copy diagrams output to dxf file laser ready

    I wanted to show how easy it is to setup the draw routine and a rollup tablet.

    The rollup can be configured 2 ways ,one just plug it in and the rollup provides
    the driver or down load the tablet driver routine and run it
    This shows the built in driver
    ,somewhat easier to set up and this is all very portable ,and the end result is a
    *.dxf file and can be editted
    whch i will be showing next
    This rollup is
    36x30 ,and they can be smaller

    john walsh's draw routine with a rollup tablet - YouTube
    Attached Thumbnails Attached Thumbnails one.jpg  
    Reply With Quote Reply With Quote
  2. 01-20-2014, 03:34 AM #2
    woodman08
    woodman08 is offline Member
    Join Date
    Oct 2007
    Posts
    1022
    and example

    trace a pattern using the draw program and produce a machine ready cut - YouTube
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Schematic Diagrams/Block Diagrams of Fanuc Modules
    By leor in forum Fanuc
    Replies: 4
    Last Post: 02-15-2023, 08:37 PM
  2. My laser engrave wont trace objects, only cuts using horizontal or Vertical paths
    By ElationArt in forum Laser Engraving / Cutting Machine General Topics
    Replies: 1
    Last Post: 08-15-2012, 01:18 PM
  3. Acramatic 2100. NC ready signal on PLC output missing
    By deepforrest in forum Cincinnati CNC
    Replies: 2
    Last Post: 09-23-2010, 07:54 PM
  4. how to copy file in PUMA 400L
    By ming035 in forum Community Club House
    Replies: 0
    Last Post: 11-17-2009, 07:24 PM
  5. Windows based laser engraver software - Hardwired to LPT1 - redirect output to file
    By sidi_steve in forum DNC Problems and Solutions
    Replies: 6
    Last Post: 05-09-2006, 03:52 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules