[Babba]

I'm trying to mate 2 parts together simply because I cannot work out how to make this as one part.

It's basically a rectangular part that needs to mate to a cylinder but I need to do it in a way that I can fillet the join?

Attachment 221248

I've probably gone about it all wrong, any help much appreciated.

[cygnus x-1]

There are several ways to do this. You can mate them together in an assembly or in a part (using insert body), or make it as a single part. I would say it's easiest to make it as a single part. Can you post the two part files here? It would be easier to show you how to do it than explain.

C|

[Babba]

Can't see how to post files here?

I've asked the same Qu at Grabcad, files are available there : https://grabcad.com/questions/how-to...-to-a-cylinder

[cygnus x-1]

Oh, ok. I'll go there then.

C|