[jsclark]

Im trying to figure out how to modify my gcode for a sub routine. I have posted my gcode below and I cutting the end of a part off at 4 different offsets. I was wondering how I can make it repeat 1 time at E1, E2, E3, and E4. Thanks.

I have a 2004 fadal 4020 with MP32 control same as cnc88hs.





%
O1000
(COMPENSATION-WEAR)
(Post Rev 0.71)
(FEB-01-2014-4:46:39PM)





(TOOL 21 - DIA 0.75)





N1 G90 G17 G40 G80 G00
M06 T21 ()
(STOCK SIZING)
A0.
G00 E1 G90 X8.2598 Y0.5 S5500 M03
G43 H21 Z0.5
(-----LOOPING LAST TOOL CHANGE CODE-----)
X8.2598 Y0.5
Z0.5
Z0.1
G01 Z-1.4434 F200.
Y-5.0003 F150.
G00 Z0.5
(-----LOOPING LAST TOOL CHANGE CODE-----)
E2
X8.2598 Y0.5
Z0.5
Z0.1
G01 Z-1.4434 F200.
Y-5.0003 F150.
G00 Z0.5
(-----LOOPING LAST TOOL CHANGE CODE-----)
E3
X8.2598 Y0.5
Z0.5
Z0.1
G01 Z-1.4434 F200.
Y-5.0003 F150.
G00 Z0.5
(-----LOOPING LAST TOOL CHANGE CODE-----)
E4
X8.2598 Y0.5
Z0.5
Z0.1
G01 Z-1.4434 F200.
Y-5.0003 F150.
G00 Z0.5
M05
G90 H0 Z0
E0 X0 Y0
M30
%

[Beltdrive]

%
O1000
(COMPENSATION-WEAR)
(Post Rev 0.71)
(FEB-01-2014-4:46:39PM)





(TOOL 21 - DIA 0.75)
L100
G0G90A0.
G00 G90 X8.2598 Y0.5
G43 H21 Z0.5
(-----LOOPING LAST TOOL CHANGE CODE-----)
X8.2598 Y0.5
Z0.5
Z0.1
G01 Z-1.4434 F200.
Y-5.0003 F150.
G00 Z0.5
M17
M30

G90 G17 G40 G80 G00
M06 T21 ()
(STOCK SIZING)
A0.

G00 E1 G90 X8.2598 Y0.5 S5500 M03
L101
G00 E2 G90 X8.2598 Y0.5
L101
G00 E3 G90 X8.2598 Y0.5
L101
G00 E4 G90 X8.2598 Y0.5
L101


M05
G90 H0 Z0
E0 X0 Y0
M30
%