[mrpackethead]

Long story, but project got sidelined because i was really too busy.. I've got all the motors and mechanics attached to my Super X3, but am Stuck with getting the motors and drives wired up. I hoping osmeone can provide me with a schematic diagram of how i should wire this thing together. The information probably is out there somewhere, but i'm lost, and i did'nt really have any luck with the suppliers who did'nt give me much information.


I'm happy to pay a reasonable amount to someone who can provide a working schematic.

I have 2 x KL23H286-20-8B motors for the X and Y axis ( Automation Technologies )
1 x KL32H295-43-8A for the Z Axis ( Automation Technologies )
2 x KL-5042 Drives ( Automation Technologies )
1 x KL-8060 Drive ( Keeling )

1 x Ethernet Smooth Stepper ( Rev 1 )
1 x C25R3-S1227-10 Breakout board

1 x Meanwell RSP-1000-48 ( 48V AC-DC power supply )

I'll be using Mach-3 to drive it.

Surely someone out there will have the know-how.

[mrpackethead]

Big thanks to someone who sent me some diagrams with correct wiring and details on it!

[mrpackethead]

And now we are going. I'll be writing this up shortly.