I'm trying to figure out what it takes to get Mach3 to work with the Parker Compumotor ZX610 servodrives. We've been using the Xware terminal so far and other than Xcode I don't see where the drive accepts any other type of inputs but maybe I'm missing something. Anybody know about this?
Jim
Thread: Anyone know the Parker ZX drive?
Results 1 to 2 of 2
-
02-04-2014, 04:07 PM #1
Registered
- Join Date
- Mar 2010
- Posts
- 59
Anyone know the Parker ZX drive?
-
02-23-2014, 04:52 PM #2
Registered
- Join Date
- Mar 2010
- Posts
- 59
Follow-up:
The ZX is a single axis controller using an ASCII proprietary command language input on a serial port. No amp level inputs, although earlier versions did have that. Not conducive to coordinated multi-axis use. Coordinated moves are possible, if programmed in Xware. These will be used for awhile and then replaced with standard servo amps.
Jim
Reply With QuoteSimilar Threads
-
WTB Parker E-AC drive
By shadowless in forum Want To Buy...Need help!Replies: 0Last Post: 08-26-2011, 12:24 AM -
parker oem drive
By funkenpedro in forum Stepper Motors / DrivesReplies: 0Last Post: 05-30-2011, 07:54 PM -
Parker automotion E-ac drive
By cncgabe in forum Mach Software (ArtSoft software)Replies: 0Last Post: 11-17-2010, 02:45 AM -
Parker SX8 Drive question
By darxtar1 in forum Stepper Motors / DrivesReplies: 0Last Post: 03-28-2010, 07:37 PM -
Parker SV-M drive : limit switches?
By toninlg in forum Servo Motors / DrivesReplies: 0Last Post: 08-06-2008, 06:11 PM
Tags for this Thread
Posting Permissions
