[dcoupar]

It is because the Fanuc only sends 'Line Feed' as end of line, not CR/LF

If it's a 6M-B then parameter 8 bit 7 can be set to 0 to output "LF CR CR" or 1 to output "LF".

[MarcoGuerrero]

I have a machine center MORISEIKI MV35/40.fanuc6m
For the transfer from machine to pc it works
To transfer from the PC to the machine it works
But DNC mode the machine does not work
when push start boton cycle start dhe green led lit ut dhe machine not work
help me plees
beste regard

Can you send me a picture of your first PC parameters please [email protected] or wrapped 442 476 0463