Hey guys, my tool changer is about an inch off of where it should be when in position. I'm not sure if the operator crashed the ATC while indexing or what. Anyway, I need to manually reset the zero or home position for the ATC. Does anyone know of the parameter that I can set for the ATC with a Fanuc 18?
Thread: Hitachi Seiki VS 60 Fanuc 18
Results 1 to 3 of 3
-
02-18-2014, 03:59 PM #1
Registered
- Join Date
- Feb 2014
- Posts
- 1
Hitachi Seiki VS 60 Fanuc 18
-
02-20-2014, 10:26 PM #2
Registered
- Join Date
- Sep 2010
- Posts
- 125
you only have to turn by hand your magazine still the pot number one is in transfert position and then only to set parameter 1815 (apz) of the 4th axis in fanuc side To 0 , then to 1 .that's all
-
02-21-2014, 02:30 PM #3
Member
- Join Date
- Dec 2009
- Posts
- 539
Hello,
let me know if you still need help.
John
Reply With QuoteSimilar Threads
-
Hitachi Seiki 4NE11 Fanuc 6TB
By Leblondmakino in forum FanucReplies: 20Last Post: 11-08-2014, 12:22 PM -
Hitachi Seiki VA 35 mill w/ 6m fanuc
By rdstillw in forum DNC Problems and SolutionsReplies: 0Last Post: 12-27-2013, 05:28 PM -
Hitachi Seiki w/ Fanuc 18 C
By jumpstart in forum Uncategorised MetalWorking MachinesReplies: 0Last Post: 03-16-2010, 09:20 PM -
Hitachi Seiki Fanuc 11M Parameters
By diegojulio in forum Vertical Mill, Lathe Project LogReplies: 0Last Post: 03-03-2009, 12:33 AM -
HITACHI SEIKI / Fanuc 11m
By mn12mike in forum FanucReplies: 2Last Post: 12-14-2008, 06:06 PM
Tags for this Thread
Posting Permissions
