we are trying to machine a ramp on a part using mastercam x6 for solidworks. when it is machined it leaves a step at the bottom of the ramp and we can't get it to go deeper. If you look at the image that shows the toolpath it isn't touching the part. I'm using a 12mm ball nose cutter and using surface highspeed (raster) toolpath. Anyone got any ideas?
Results 1 to 2 of 2
-
02-16-2014, 12:49 AM #1
Registered
- Join Date
- Apr 2011
- Posts
- 95
problem with a 3d cut mastercam x6
-
02-20-2014, 11:09 AM #2
Registered
- Join Date
- Aug 2012
- Posts
- 63
Containment boundary? Geometry selected to cut? MC is most likely stopping to avoid collision of the bottom surface or to stay within containment.
Reply With QuoteSimilar Threads
-
mastercam PP problem
By basim in forum Post Processors for MCReplies: 4Last Post: 12-13-2009, 03:27 PM -
Mastercam offset problem
By kcritch in forum MastercamReplies: 4Last Post: 11-28-2008, 12:55 PM -
Mastercam problem
By deckhand in forum MastercamReplies: 6Last Post: 11-22-2006, 06:08 PM -
Problem/mastercam Config
By DELL in forum Community Club HouseReplies: 0Last Post: 07-21-2006, 12:03 AM
Tags for this Thread
Posting Permissions
