[emersonja]

Hello.

I have a problem with a lathe SQT-28M, T PLUS MAZATROL control.

The battery is depleted.

I have reset according to the manual, loaded the machine parameters, tool data, offset, cutting conditions, conditions of material, data plate ... etc.

problem:

When I run the program in automatic stays in standby mode in the initial cutoff and as much as I press the start key cycle, the system will not work. The spindle is rotating at a low speed.

You could tell me that it could be happening?

Could you send me some information to solve this problem.

Best regards.

[fizzissist]

Is the door closed?

[emersonja]

No, This open, but we are running the program block by block (pressing start cycle). The display shows that the block moves only 1 to 5.

[mantenim]

antes de que la bateria fallara no tenias este problema ?
asegurate hacer la prueba con puerta cerrada, y haz pruebas con otros programas, si hace lo mismo con los otros programas, entonces suguiero reinizializar el control numerico.
tengo el procedimiento por si lo requieres.

saludos

[emersonja]

Hola mantenim.

No teníamos ese problema, nosotros ya reiniciamos el control, pero aun así sigue el problema.
Podrías enviarnos el procedimiento y las consideraciones a tomar?
Te dejo mi correo: [email protected]

Saludos cordiales.