Well my backup Arrow 1000 took a dump while waiting for the X motor to come back on the Arrow 1250C. The "Spindle Drive Not Responding" error came up with the Spindle Drive faulting out when commanded above 300 rpm from a stop. I can run it up to about 1100 rpm if I MDI it up in 100 rpm increments. I ohmed out the resolver and it comes back at 18, 18, and 30 ohms and no shorts between lines so I assume it is not the cable or the resolver.
So looking at the wiring diagram of the Vector drive off of the 1250 and the VFS5 drive off of the 100 it looks like they are nearly identical. The 1250 has the din plug on it for the controller to set parameters so if I program it from the controller to match the VFS5 will this work while I send the VFS5 out for repairs and wait for the 1250 X motor to come back?
Any thoughts?