Hi
What is the best way to get the mill linded up again after moving
the head on a round column mill ?
Thanks Steve
Hi
What is the best way to get the mill linded up again after moving
the head on a round column mill ?
Thanks Steve
Hey Steve, not sure which way you moved it but assuming left/right, there's usually a scale on the fixed frame and an arrow/notch on the head for aligning. If not, perhaps you can align the X table to center and then use that reference to align the head.
If you tilted the head and don't have a reference scale, something like this can help: http://www1.mscdirect.com/CGI/NNSRIT...46457&PMT4NO=0 For the money, though, I would make my own.
JR