Hi All,
I ordered an item that thought would be easy to hook up for use as a drill press motor replacement and am having difficulty in wireing the control unit to make it run.I am not that electrical minded, (Just enough to be Dangerous) So I SEEK the Advice of though's that are familial with this sort of thing. The motor itself runs on an Penta drive that I have for my mill spindle and is very quiet, However my knowledge in this controller has me wondering if I may have a faulty part or am Just not doing the hook up right. I have attached a picture of the cartoon that I downloaded from the site to get a grip on what I have, and wish for some advice.I have been tring all sorts of connections on the pot I have ,and with no results of movement. It's a 5K ohm and does work up and down on a volt meter. Any help is Great, For I whish I knew what I am Doing Wrong.