[CSOSA]

Hello all.

Purchased a machine a cuple of months ago, started it, tested it, and it worked ok.

Wife gets sick, no time to learn new machine, mice ate some of the wiring on the cabinet, problems begin for me.

Patched the eaten wires with black tape.

I start machine, hit f5 to go to maint. screen, Hit 7 to enable axis drive, get axis drive fault.

See parameter 153, it goes 00000000, so no problem in no axis or so she thinks.

hold down the spindle drive relay to see if the problem is there, drive starts and goes to 0. No fault code no nothing.

That is what has been done so far.

Can anyone Help?.

C.

[fejrock]

Did you do a continuity test on the affected wires? The mice may have damaged more than just the insulation. You need to use a multimeter to verify that each of those wires is still intact and capable of carrying voltage.