Hi again all,
I am trying to carve out a letter C from a block of material and then run a chamfer along the edge.
However, my chamfer pass, when posted is producing several arcs with .020 radii that should not be there. I cannot figure out why, or how to eliminate them.
they are totally extraneous and all lines with radii .020 can be deleted and the post works fine. They seem to occur at sharp the parts of the inside contour where the arcs meet?
How can I get bobcad to stop producing these small circles?
As an example the posted code looks like
Code:
Arc Ccw X0.8769 Y1.6308 Radius0.515
Arc Ccw X0.8012 Y1.6353 Radius0.6368
Arc Ccw X0.7998 Y1.6353 Radius0.6368
Arc Cw X0.7998 Y1.6353 Radius0.02
Arc Cw X0.7997 Y1.6353 Radius0.02
Arc Ccw X0.7966 Y1.6354 Radius0.5923
I have attached a zip file with the bobcad file, my post, as well as the posted code.
Appreciate any and all advice please.
Thanks
Brian