Hi guys. Just picked up MasterCAM X7 (Windows 7 Pro) and was trying to do some desk nameplates. Just letters .125 deep in aluminum. The problem is the capitols J and C (and the small i) are split in to two chains and dont toolpath correctly or at all. I set the letters to 2" high Brittanica Bold and tried a .125 bit, .0625 and finally a .030 bit. The tool path will not go around the lower part of the J to create a single toolpath.
I measured across the area and got .450 or so the width is big enough for the tool to go thru. I have tried a couple different type of toolpaths such as highspeed and contour with the same results.
I know it's something I'm missing but being new, I don't have a clue as to what to look for. What's missing?
P.S. the tool shows correctly in the left hand window.