[rss27]

Currently getting this message when exiting Solidcam: "Operation compressing failed. Original CAM-Part and SolidCAM temporary folder content will be kept." Hence, any changes I make are not actually getting saved in the intended folder.

I was originally using the 32 bit version, then switched to the 64 bit version of Solidcam 2014 SP1. Could that be the problem?

Does anyone know what the problem can be?

[imachining-6061]

Never had that error message ! You can give a try by putting the compression ratio to '0' in solid cam settings

[rss27]

Tried it, didn't work. I might have to start from the beginning if I can't find out what's going wrong.

[whagkangmakulet]

Tried it, didn't work. I might have to start from the beginning if I can't find out what's going wrong.

I just upgraded to a mobile desktop laptop and installed the 2015 SP03 HF3 and I'm getting the same error. I brought the compress level to "0" and that didn't work. If I uncheck the box for create new parts to compressed mode and close cam-part..convert non-compressed to compressed mode the error dissapear, but I now have folders with multiple parts. Anyone figure this out or experience this before, I didn't have a problem on my old workstation both are Win7 pro 64bit.?