WOW it's been along time since I posted here.

OK, So the thought was to use the mounts just to get her going. BUT after I realized how stiff these mounts actually are I think they are here too stay. And if there is a runaway issue I will only damage some plastic mounts that can be redone with relative ease.

Anyway here is the second air cutting pass that I made with it.

I have some higher torque motors to wire in today. I am hoping by the end of today or tomorrow to actually cut some metal.

I may also redo the y mount, flipping over the fixed end bearing for more y travel.

I need to find a decent solution for work piece holding......

OK enough babble heres the firs set of air passes