Ok you guys have answered all my questions on tools leading me now onto the fixture design of this part.
I've attached 3 screenshots of this part and it's 1.41" wide, 0.57" thick. I'd like to cut 4 pieces a time on a 1.5" wide 0.675" thick bar. I have a 4" shars vise and a stevens engineering tool table I can utilize. I really would like to give the tool table a try if i could. It looks so nice...but I only have a set of clamp down set to work on it. I know this piece probably would need to be set on a two vise setup, machine one side and flip over to do the other side. Am I on the right path?
Thanks in advance.
Daz
Attachment 239200
Attachment 239202
Attachment 239204