Hi
After a couple of years reading this forum i started to design my own diy plasma table. After many hours of planning i decided to contact Tom on CandCNC to buy all the hardware needed to start my build. I was then inform that Tom doesnt ship to my country. Disappointed i drop the project off.
Now i have the chance to buy an used old plasma table for about 5500 usd.
The dimension arent what i wish for i needed a bigger table but i can handle it for now.
I would like if you guys can give me an opinion if its worth it.
Some pics.
Attachment 240296
Best Regards and sorry for my crappy english
Is