Attachment 240350
hello everybody !
My old miller 's CN system is Autocon 40m ,today the machine does not work normally. The sreen display "coolant motor is overload" message.I dont know how can i do it .
Attachment 240352
Attachment 240354
Attachment 240356
Attachment 240358
To resolve this problem, I have to check the coolant moter
1. I find the moter is ok.
2.Thermal overload protector (热过载) is OK
3.Ac contactor(KM3) is OK
4.Relay (KA7) is OK
So the problem may be hanppen in SWItCH or IO board node, it is very difficuit to repair without shematic of circuit .
there is four line numbered 80,81,199,100 conected to switch for "man" "stop "auto" function , thes signal line ->keyboard panel->IO board
i dont know these lines standing for ,so i dont know how to repair .
the other question is the number 100 line conect where ?near the spindle switch .
If someone know how to do it ,please reply me ! thans very much!
If someone have manual or shematic ,pleas email: [email protected] ,thanks very much