I'm in the final stages of setting up my machine and getting all dialed in. One of the last stages is setting up the probe for setting z at 0 and whatnot. I ended up going with the Wildhorse Innovations Econo-Probe, but I had no idea it would be so lacking in setup instructions. Anyone out there have a similar setup that can point me in the right direction? Here is what I have

Mach3 < Ethernet Smooth Stepper < Leadshine MX3660

I have the probe hooked up to Input 4 on the MX3660, and the LED on the unit does light up on it when its depressed. I have the ports and pins set to port 1 pin 9 and active low enabled. No matter what I've changed, I can't seem to get the "probe active" light to light up in Ger's 2010 Screenset. Is there anywhere other than the ports and pins that I need to enable this to get it to work? I'm pretty new at this. Any input would be appreciated.

Thanks,

Jason