Hello
Does anybody know how I can activate the tool pre-selection "Tool Def" for a post processor profile on 2.5D milling?
And how can I create a independent tool data bank separately on the post processor profile?
Thank you
Hello
Does anybody know how I can activate the tool pre-selection "Tool Def" for a post processor profile on 2.5D milling?
And how can I create a independent tool data bank separately on the post processor profile?
Thank you
Hello
Activate the tool def: When you start a program (yellow arrow) then you need to go to PP settings quite far at the bottom (TNC530 settings for me), enter the password ketmac in the new window and simply click on tool pre-selection (Tool def)
I hope you can find it- if not let me know!
I can answer your second question though...
Kind regards