Hello Sivilo
There are several possibilities to integrate measuring cycles in a topsolid’CAM program: the easiest and most flexible one is to create a ‘group of basic operations’ with the measuring probe.
Then you first do a movement to a safe point where you can start your cycle on the machine. Afterwards you can add a ‘direct block’ in which you describe your desired measuring cycle. The measuring cycle can also be saved in *.txt format and called later on.
That is for sure the easiest and also the most flexible method there is!
It seems that that you don’t just want to measure but also trigger an action according to the results.
You can do that depending on the situation. That should all be possible without any PP adjustments as these are standard functions of TopSolid’CAM. The only disadvantages is that the cycle itself is not simulated Only the start up to the point and the back down afterwards is simulated. I think that it’s enough though as you should know anyway what the cycle does.
Another possibility would be to replicate the cycles with processes or to use the ‘reference point’ function.
Both however is a little bit inflexible, created a lot of effort in PP and only makes sense when you always want to do the same measurement with the same behaviour and simulation.
Greetings Sven