Hello everybody,
Please HELP me!!!circular grinding machine TACCHELLA 13059 control system FAHNUC 21i-TB.
Alarm "300 APC ALARM:B AXIS NEED ZRN" (accidently switched after the measuring system connector.
Or was it coincidence)
Machine can only be operated manually, X and Z axle. With hand wheel or arrow keys.
Axle X until the software switch,
Axle Z runs until the Hardware switch-emergency STOP.
Axle B can only run towards X and Z referencing, but that doesn’t work currently.
When I confirm the key ‘reference drive’ then the key ‘start cycle’ blinks, I press ‘start cycle’ and nothing happens (in the past reference points were approached)
My question: how can I reset "300 APC ALARM:B AXIS NEED ZRN?
What parameters need to be changed?
Or maybe there is a magical key combination like "CAN"+"P" (FANUC 8i or something like that)
Thanks a lot in advance
Andrej Bär