Hello,
I have a problem with our Index machine.
Today the GS42 began to refuse turning of programmed bevels.
It stays and waits for something.
If I change to the single block mode, the bevel is made. If I change to automatic again, the machine works until the next bevel comes.
If I program it manually, it works
.
G1 X28.8 Z.05 F.1
X29.8 B-.5
Z-20 B-.5
X28.8
.
Doesn’t matter, with stress corrosion cracking or without it. The machine stands still.
.
G1 X28.8 Z.05 F.1
X29.8 Z-.5
Z-19.5
Z-20 X29.8
.
I have already made the drift calibration.
MD 231 and 232 with Edit + S. Everytime the value changes.
It’s most between -4 and +3
Does anyone have an idea?