Hello guys

Today, I have worked on a g200 840c controller software status 4.

After finishing an order, lets called it wave1, I had to retool the machine.
I have saved the tool data geometries, corrections and so on. The machine immediately created a program. Main program of the wave 1 is called mpf2035; the tool data mpf1335. I have deposited it in memory 1 with lathe tool description srk, d-number and space number- it all went well. I have deleted the geometry and the tool data in the wear correction because I had to retool the machine.

The new order, let’s call it wave 2, has the part programming no. mpf2065 and the tool data program no. mpf 1365. I have selected the part program no., wave 2 and the tool data program no. in the ‘control process’ – so far so good! Now I went to ‘total equip’ and ‘tool change’ and of course I pressed in the automatic key lock setup start.

The part program was nicely uploaded in the NCK area apart from my tool data with lathe tool and so on... . They were not uploaded in the wear correction geometry.
What have I done wrong?

Please help me out!

Thank you in advance