[KULTIVATE]

Hello
Could anybody explain to me all the 0 and 1 in the TPC-data (if I run a program with a pocket, I theoretically could make it via die TPC-data settings, e.g. start point … - then is a blue + before the cycle in program (Mazatrol program))?

Regards, Martin

[RoSch]

Hello Martin

It would be meaningful to read the Mazak manual.
Everything has to be explained there.
I’m not going to say anything about these books. I don’t want to get a chewing out.

And the blue + shows that the TPC data were changed in this item.

You can change different values, e.g. pocket milling from inside to outside or contrariwise, your distance to the milling contours, feed values for dipping etc.

Regards, Robert

[JJIntegrex200IV]

Hello Martin

It would be meaningful to read the Mazak manual.
Everything has to be explained there.
I’m not going to say anything about these books. I don’t want to get a chewing out.

And the blue + shows that the TPC data were changed in this item.

You can change different values, e.g. pocket milling from inside to outside or contrariwise, your distance to the milling contours, feed values for dipping etc.

Regards, Robert

Hello
I don’t understand the manual.

You need your parameter list.
Those are E-parameters for Matrix
E1 E2 … E95
You have to look in your TPC data and try

Greetings
JJ