586,110 active members*
3,271 visitors online*
Register for free
Login

Thread: Breakout Board

Results 1 to 3 of 3
  1. 07-28-2006, 05:31 PM #1
    bkkpool
    bkkpool is offline Registered
    Join Date
    May 2006
    Posts
    9

    Breakout Board

    I am relatively new to this forum and this is my first post.
    I have been reading up on as much as possible because I am building my first CNC router. I was wondering if someone can recommend a breakout board to me and any pros and cons. I am going to be using Gecko 212 drives and Mach3 software.

    Brian
    Reply With Quote Reply With Quote
  2. 07-28-2006, 07:08 PM #2
    sdantonio
    sdantonio is offline Registered
    Join Date
    Nov 2005
    Posts
    938
    cnc4pc makes the C-10 breakout board. Highly recomended. Another poster here, Jerry, put this together. You may find it useful.
    Attached Files Attached Files
    If you cut it to small you can always nail another piece on the end, but if you cut it to big... then what the hell you gonna do?

    Steven
    Reply With Quote Reply With Quote
  3. 07-28-2006, 07:15 PM #3
    sdantonio
    sdantonio is offline Registered
    Join Date
    Nov 2005
    Posts
    938
    This is actually Jerry Clark's newest diagram. The BOB he uses is the c-10
    Attached Files Attached Files
    If you cut it to small you can always nail another piece on the end, but if you cut it to big... then what the hell you gonna do?

    Steven
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules