Hello
Our factory has got a Haas TM3 for a short time. One question: is it possible to make a specific feed motion in the manual mode? And is it in the manual mode possible to say that for example Z is zero?
Thanks
Hello
Our factory has got a Haas TM3 for a short time. One question: is it possible to make a specific feed motion in the manual mode? And is it in the manual mode possible to say that for example Z is zero?
Thanks
Zeroing is now clear. Works with origin.
Hello
As far I know, it’s impossible to set any specific feed motion in the manual mode. But you can regulate four options in 10% steps in the area from 0% to 200%. Within 5 years that I’ve been working with Haas, I haven’t managed to find a possibility to program a certain feed motion in the manual mode (not MDI).
Regards
Hajo
Schnell, gut, billig!!! (Bitte kombinieren Sie zwei der drei Eigenschaften...)<br /><br />Man kann alles machen, aber nicht mit jedem!!!