Hello everybody
I have another problem with the tool changer!!!
When we bought the machine (Maho800C / manufacturing year 1990 / 30.146 operating hours / 30fold changer / CNC432) we encountered the problem for the first time:
We got the error message "ERR E180"- no counting pulse from the tool magazine.
After a conversation with Maho ( many thanks for your help at this point) we knew the following:
We should change the constants: 80,1020,1090,1091 and 1092 and switch off the machine.
Thereby the marker is reset to zero. Afterwards the machine should be switched on again and reset all constants to their old value.
Is all worked perfectly! Tool changer worked again.
Yesterday ( after 3 weeks) we wanted to start a program and the following error messages came up:
1. ERR E111 = Gripper 0 degree 0 signal
2. ERR E180 = no counting pulse from tool magazine
3. ERR E116 = tool change position incorrect in magazine run
4. ERR E185 = tool in tool gripper
After restarting the machine, the errors still exited.
So out of desperation, we change the constants again (like Mahio explained it).
Afterwards the machine worked without any problems.
Can anybody tell me why??
It’s good that the machine is running again but I would like to eliminate the source of the problem.
Many thanks for your help in advance