Hello
Were all the following points considered?
•G862 cycle cut-in contour along Z
•Z= coordinate where the programmed contour of the cut-in begins.
•The starting point (block before G862) and ending point (block after G80) of the contour need to have the same Z value.
•The starting point in X needs to be at least around the cutting radius before the contour.
(incorporate G57)
•The X value in block before G40 has to be smaller than the X value in the block before G862.
Eine Schraube ohne Gewinde ist ein Nagel<br /><br />Grüsse aus dem Harz - InTex<br />