586,364 active members*
3,100 visitors online*
Register for free
Login

Thread: Cycle 6 countersinking

Results 1 to 2 of 2
  1. 04-26-2010, 08:17 AM #1
    rotkittel2
    rotkittel2 is offline
    Join Date
    Mar 2006
    Posts
    52
    Hello everybody
    After several years I started to work at Deckel FP3A with iTNC 155 again.
    I’ve got the following problem. The cycle 6 countersinking first racks out the contour and them countersinks. What parameter can it be set vice versa with? Or better in the program?
    Regards, Fred
    Reply With Quote Reply With Quote
  2. 05-13-2010, 02:34 PM #2
    momperbaby
    momperbaby is offline
    Join Date
    Aug 2009
    Posts
    39
    Hello
    I’ve had a similar trouble at TNC 426/430. The problem was in the compensation of the milling cutter. I programmed a contour in parallel feed. It was correct. But I had to write RR for the right side of the contour (counter direction) instead of RL for the left side of the contour (parallel feed). It worked then. Turning direction can be declared at the controller. Counterclockwise, the machine works however in ganging, it countersinks first and then makes the contour.
    Regards, momperbaby
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules